- 385.00 - 650.00 INR
The Mipro-EP Primer Epoxy Coating is a sealer that provides a strong surface finish on top coats that are added. Zinc phosphate, a corrosion-inhibiting pigment, is used in a two-part epoxy primer. Epoxy primers may be used to waterproof materials, preventing oxidation of the metal surfaces. Since paints in the automotive and marine industries are critical for preventing corrosion, epoxy coatings are often used as primers to strengthen metal surface adhesion. Epoxy primers are also used in structural steel coatings with a high build thickness.
MIPRO-EP is an 100% solid epoxy polyamide primer.
Specially formulated high viscous product for use with the mortar or any high built system that requires extra bonding properties. Exhibit excellent adhesions between mortar and the substrate and enhance the application of this high built system.
BENEFITS Fast drying. Excellent adhesion to concrete. Compatible with most surfaces and top coat. Maximum thickness for working with mortar system.
COLOURS Dark amber
Substrate to be coated must be sound, clean and free from any contamination. Enclosed shot blasting or scarification should be employed followed by thorough vacuuming. All applications must be carried out in accordance with manufacturers' written instructions.
APPLICATION PROCEDURE Surface preparation Method are depending on the type of surface and service condition which it will operate. Specific recommendation.
Stir each component separately using a slow speed (300-400) electric drill fitted with a paint mixer or a wing type mixing paddle. Then pour the entire content of Part B into Part A and continue to mix for 2-3 minutes before use.
Apply MIPRO-EP within its pot life.
For excellent performance, no thinning required.
Method Of Application
Brush, roller (short hair mohair roller) Epoxy mortar screed should be laid immediately after the primer is applied before it dries up.
Health & Safety
Strict precautions as the use of other combustible, volatile solvent must be observed. Some of the components of this product may be hazardous during mixing and application. For further information, refer to the product Material Safety Data Sheet , available upon request.
With a wealth of technical and practical experience built up over many years in pursuit of excellent especially in the flooring and concrete technology, make us your partner today Contact us at hot line below.
60 deg C
No. of coats recommended
No. of component
1:05 by weight of Part A & Part B
30 mins at 32 deg C
Touch dry : 2 to 3 hour
6 hrs at 32 deg C
5 & 20 kg
- 100-1000000 Per Day
- 1-7 Days
Plot No. 2114, Phase-III, G.I.D.C., Vatva, Ahmedabad, Gujarat, 382445, India